I’m looking at this
It is not an LED star, like a tri-cree (if that’s what you mean).
You can still use the V2.2 configurator as a guide. Where the strip is reprsented there are 3 wires:
The red wire goes to the + pads on the connector, closest to the edge.
The black wire goes t othe - pads on the connector, closer to the center.
The pink wire goes to the D2 pad.
I see two resitors on the connector, but only one D pad. This suggests that the LEDs on the surface of the connectore are wired in parallel with the blade data. One blade style should be enough for each preset.