A Newb trying to get the most out of the proffie I burned up. It is now a guinea pig/ fit function prototype. In this case I’m trying to find a secure way to install switch LED resistors. Note: resistors would not be attached at these locations.
If you really want to get the most out of it, sell the parts!
I would probably put the resistor near the button, or in-line in the wire and covered with shrink tube.
Yes, that is what I’ve been trying to do. After breaking a couple I was curious if there was someother way. I posted partly in humor because because I have had a helluva time this week trying to complete my first installl, a simple two button neopix/proffie/mhs saber. I have a new appreciation for the skilled saber builders especially Tom Tillmon, aka Meg Tooth Sith.