Fried pfet

Proffieboards
1

Hey folks! Long time listener, first time caller here, lol. So after a late night repairing my lightsaber, found my main ground had broke off the board. Cleaned it all up and reattached it, but I apparently shorted something out in the process, because I fried the dual pfet. I’ve already ordered a new board, and will try and replace this pfet eventually, but with it being a week from Halloween, and not wanting to revert my saber to a baselit darkwolf board, I understand that the pfet can be bridge for a crude temp fix? Just looking for a roadmap to which leads that need bridging. My mossfet theory is a bit rusty!

Thanks all!

2

The answer comes from reading the data sheet.

So, this is the dual pFET (Q7):
https://fredrik.hubbe.net/lightsaber/v6/partmap.html#q7

Here is the data sheet:

From the data sheet, we can see that we need to short D1 to S1 and D2 to S2, which means straight across the chip at the top and bottom (but leave the mid pins unconnected).

3

See, I figured that, but I wanted to be sure! Thank you!