Crystal chamber won't ignite

[T_Kita]

@Sabersense

Basically your hilt has been wired for just one blade style, with blade and crystal both sharing the same data line and displaying the same style (budget hilts very rarely wire to different data pads or wire LEDs in series for independent control).

Hi Sabersence I dont quite understand the coding there’s only 1 blade defined and no code for the crystal chamber. Is it possible to wire data2 to the chassis connection shared with data1? Or does data2 have to be separate wire leading to the emitter?
The CC was working before I flashed a new OS7 config to the saber.

I found this from NoSloppy, but I can’t quite make sence of it:

Off behavior in crystal chamber

You can’t have 2 separate blade definitions like this if you have them wired in parallel. Each blade needs it’s own bladePin (data pad) assignment. WS281XBladePtr<140, bladePin, Color8::GRB, PowerPINS<bladePowerPin2> >(), WS281XBladePtr<2, bladePin, Color8::GRB, PowerPINS<bladePowerPin2> >(), To control the crystal LED independently, you need to either wire it’s data line to it’s own data pad on the board, or wire it in series with the blade and use SubBlade in your BladeConfig for them. Unless you rewire, you are stuck with them mimicking each other and sharing a single blade style.

Thanks for your help